|
Pulley
: Design Input Requirement for enquiries |
|
| Customer Name | |
| Email
: |
|
| Address : | |
| A. Conveyor Numbers | |
| a. Belt width | _________________mm |
| b. Belt Speed | _________________m/s |
| c. Material conveyed | |
| d. Conveyor Capacity | _________________tph |
| e. Bulk Density | _________________kg/m3 |
| f. Tension | |
| i. Tight Side | _________________KN |
| ii. Slack Side | _________________KN |
| g. Angle of Wrap | _________________deg |
|
h.
Maximum Deflection Allowed (L/D) |
|
| i. Max. Slope allowed | _________________min |
| j. Max. Torsional deflection | |
| k. Type of Pulley | |
| i.
Diameter : |
_________________mm |
| ii.
Face Width : |
_________________mm |
| iii. Bearing Centre to Centre : | _________________mm |
| iv.
Shell Thickness : |
_________________mm |
| v.
Shaft Diameter at Hub : |
_________________mm |
| vi.
Shaft Diameter at Bearing : |
_________________mm |
| vii. Shaft Length : | _________________mm |
| viii.
Shaft Extension : |
Single/ Double Side |
| ix.
Shaft Major Diameter : |
_________________mm |
| x.
End Disc Type : |
Cast / Plate with Hub |
| xi.
End Plate Thickness : |
_________________mm |
| xii.
Centre (Stiffener) Plate : |
Yes/ No |
| xiii.
Centre Plate Thickness : |
_________________mm |
| xiv.
Number of Centre plates : |
_________________no |
| xv.
Shaft to Hub Connection : |
Key / Weld on Hub / Locking Assembly (Ringfeder) |
| xvi.
Type of Key : |
Parallel / Gib Head |
| xvii.
Bearing Type : |
|
| xviii.
Bearing Number : |
|
| xix.
Plummer Block Number : |
|
| xx.
Materials of Construction |
|
| 1.
Shell |
|
| 2.
Shaft |
|
| 3.
End Casting |
|
| 4.
End Plate/ Centre Plates |
|
| 5.
Hub |
|
| xxi.
Schedule of Quantities : |
|
| 1.
Type of Pulley |
|
| 2. Quantity | |
|
FOR
SPECIAL TYPES PLEASE PROVIDE GENERAL ARRANGEMENT DRAWING IF AVAILABLE. |
|